How to store surfboards in a garage without wrecking them

Most damage to a surfboard happens on land. Boards leaned against a garage wall slide, fall and take knocks on the rails and nose. Boards stacked flat on concrete pick up pressure dings from their own weight. And an uninsulated Australian garage in February can sit above 35°C, which is enough to delaminate an older epoxy.

The fix is boring: get boards upright, off the floor and supported at two points. A freestanding surfboard rack does all three at once. Vertical storage means gravity works down the stringer instead of across the deck, so there is no long-term flex, and the fins sit clear of everything.

Where you place the rack matters as much as the rack itself. Keep boards away from the western wall, away from the roller door where afternoon sun radiates, and out of the path of car doors and bikes. If your garage is genuinely hot, a light board sock will buy you a lot of protection for very little money.

Padding is the other half of it. Bare timber or steel on a wet rail will eventually leave a mark. Every contact point on a SurfBros rack is wrapped in high-density closed-cell foam so the load spreads across a wide surface instead of pressing into one spot.

Finally: rinse and dry before storing. Salt draws moisture, moisture finds any open ding, and an open ding in a warm garage becomes a delam by winter.